Adds standard breaklines to the surface from a collection of 3d points.

Namespace: Autodesk.Civil.DatabaseServices
Assembly: AeccDbMgd (in AeccDbMgd.dll) Version: 13.4.2516.0

Syntax

C#
public SurfaceOperationAddBreakline AddStandardBreaklines(
	Point3dCollection points,
	double midOrdinateDistance,
	double maximumDistance,
	double weedingDistance,
	double weedingAngle
)
Visual Basic
Public Function AddStandardBreaklines ( _
	points As Point3dCollection, _
	midOrdinateDistance As Double, _
	maximumDistance As Double, _
	weedingDistance As Double, _
	weedingAngle As Double _
) As SurfaceOperationAddBreakline
Visual C++
public:
SurfaceOperationAddBreakline^ AddStandardBreaklines(
	Point3dCollection^ points, 
	double midOrdinateDistance, 
	double maximumDistance, 
	double weedingDistance, 
	double weedingAngle
)

Parameters

points
Type: Point3dCollection
A collection of 3d points used to create breaklines.
midOrdinateDistance
Type: System..::..Double
When the breakline is defined from a polyline with curves, the midOrdinateDistance value is used to tessellate the arcs in the polyline.
maximumDistance
Type: System..::..Double
Specifies the maximum distance between vertices. If the distance between vertices on a breakline is greater than the maximumDistance, then points are added along the breakline at equal intervals that are less than or equal to the maximumDistance.
weedingDistance
Type: System..::..Double
The distance value for the weeding factor.
weedingAngle
Type: System..::..Double
The angle value for the weeding factor.

Remarks

  1. The weeding factors ignore both vertices that are closer together than the distance factor and vertices that deflect less than the angle factor.
  2. Set a parameter to 0 to ignore it.

Exceptions

ExceptionCondition
System..::..ArgumentException Thrown when:
  1. The count of points is less than two.
  2. midOrdinateDistance <= 0.0 , maximumDistance < 0.0 or weedingDistance < 0.0.

See Also